Truck Mount Litter, Shavings, and Compost Spreaders LS-3420

Warren Litter Spreader Body Construction:

Simple and economical hydraulic power system
Large capacity stainless steel hopper body for profitable and long life operation

All electrically welded A1011 A-45 high tensile steel
Welded in bed type jigs and fixtures for accurate fit & alignment
10 Gauge sides/sills form the hopper sides in one piece with no horizontal seam corrosion pocket
Full slope 10 gauge trapezoidal side supports are located at each cross sill and hold sides at a 45 degree angle
“Tapered-in” front and rear for better material seal and reduced power requirement
7 Gauge (3/16″) steel conveyor bottom with angle type support stiffeners
12 Gauge skid resistant surface catwalks serve as fenders with mud flaps

Overall Width: 34″
Conveying Width: 18″ with a 12 “x18” maximum feedgate opening
Pintle type conveyor chain with 7/16″ hardened pins and 2 1/4″ pitch
3/8″ x 1 1/4″ cross bars are welded to every other link
Eight tooth steel sprockets mounted to 1 1/2″ diameter idler shaft and 2″ diameter drive shaft
4″ chain idler adjustment with anti-friction bearings
Rear belt type sprocket sealers and “bolt-in” conveyor chain shields.
Hand crank type feedgate control and flow divider controls
Drive: Heavy duty 6:1 reduction gearbox