Project Description
Pull Type Litter and Compost Spreaders
The Warren LST-3420 is a hydraulic powered spreader trailer for spreading lightweight bulk material such as: chicken litter, sawdust, shavings, compost, rice hulls, or other organic material.
Simple and economical hydraulic power system
Large capacity stainless steel hopper body for profitable and long life operation
Warren LST-3420
Litter & Compost Spreader Specifications:
- Welded in bed type jigs and fixtures for accurate fit & alignment
- 10 gauge sides/sills form the hopper sides in one piece with no horizontal seam corrosion pocket
- Sides/Sills and 10 gauage end gates have inverted “J” formed top edge for extra strength without corrosion pockets
- Full slope 10 gauge trapezoidal side supports are located at each cross sill and hold sides at a 45 degree angle
- “Tapered-in” front and rear for better material seal and reduced power requirement
- 7 gauge (3/16″) steel conveyor bottom with angle type support stiffeners
- 12 gauge skid resistant surface catwalks serve as fenders with mud flaps
- 54″ Hopper Height; 88″ wide
- Overall Width: 34 “
- Conveying Width: 34″ with a 12″ x 34″ maximum feedgate opening
- 3/8″ x 1 1/4″ cross bars are welded to every fourth link
- Six tooth steel sprockets mounted to 1 1/2″ diameter idler shaft and 2″ diameter drive shaft
- 4″ chain idler adjustment with anti-friction bearings
- Hand crank type feedgate control
- UHMW Liner
- Two 24″ diameter canted spinners
- Spinners have 3 formed replaceable fins with adjustable angle
- Protective spinner guard
- Chassis: Rigid frame construction of 8″ structural steel channel
- Hitch Pin: Adjustable height, single pin with safety chains
- Axles: Single, Rigid with 19L x 16.1 Farm Flotation Tires
- Axles: Tandem Walking Beam Suspension with 12.5L x 15 Tires or 16.5L x 16.1 Flotation Tires
Pull Type Litter and Compost Spreader Sizes:
| Spreader Length | 14′ | 16′ | 18′ | 20′ | 22′ | 24′ |
| Capacity (cu. yds) | 11.3 | 12.9 | 14.6 | 16.2 | 17.8 | 19.4 |
| Spreader Length |
Capacity (cu. yds) |
|---|---|
| 14′ | 11.3 |
| 16′ | 12.9 |
| 18′ | 14.6 |
| 20′ | 16.2 |
| 22′ | 17.8 |
| 24′ | 19.4 |
Pull Type Litter Spreader Options:
30″ Spinner Discs
1000 RPM PTO Drive Line
Inverted “V” Divider
60° Hopper Sides
201 or 304 Stainless Steel Construction (All or Partial)
#3 Chain Conveyor w/ Bar Every Link
#6 Stainless Steel Mesh Chain Conveyor
Tarp System
Rate Controllers
GPS Guidance Systems
Hydraulic Operated Feedgate
Electric on/off Cab Control for Conveyor
Special Paint / Graphics
